Table Of Contents

Cross references properties

The main advantage of using Master and Slave elements is the posibility to create cross references (links) between elements. At the case of cross references definition, QElectroTech provides the posbility to display automatically at the workspace some information from the Master or Slave element linked.

The definition or cross references properties inside a project can be costumized by the user at project properties.

Note

QElectroTech allows defining automatically cross references properties during project creation. For more information about how to standarize some cross references properties from project to project, please refers to the QElectroTech cross references settings section.

The Cross references tab from New folio settings section allows pre-defining some cross references properties:

  • Cross references Master element type (Coil, organ of protection or Switch/button).

  • Cross references label (Master and slave cross references label to be display at the workspace)

  • Representation position from the cross references label (Under the element label or Footer).

  • Display option from cross references

Note

The cross reference label can be created using the general variables from Master and Slave elements.

../../../_images/qet_project_cross_references_prop.png

Figure: Project cross referencing properties window

To define cross references settings:

  1. Display project properties PopUP window.

  2. Go to New folio section.

  3. Go to Cross references tab.

  4. Define the desired parameters for each field.

  5. Press OK button to save the configuration changes and close project properties PopUP window.

Note

All pre-defined cross references properties defined at QElectroTech settings PopUP window will be automatically defined during project creation at project properties. The cross references properties can be found at Cross references tab tab from New folio section.